Stayhungry Products

Our Products
Twin screw weight loss feeder

1. Adopt single feedback to control the feeding technology, eliminating the problems of PLC signal acquisition lag, slow running speed, poor anti-interference performance, etc., increasing speed feedback, higher feeding accuracy and stability.


2. The feeding part is easy to disassemble and easy to clean, replace and maintain.


3. Horizontal mixing and optional vertical mixing design, with high anti-bridge performance.


4. Different models adopt universal screw interface, which can easily replace different types of screws to achieve a wider feeding range of one equipment.


5. Accuracy can reach ±0.5%.

产品介绍

product description:


1. Adopt single feedback to control the feeding technology, eliminating the problems of PLC signal acquisition lag, slow running speed, poor anti-interference performance, etc., increasing speed feedback, higher feeding accuracy and stability.


2. The feeding part is easy to disassemble and easy to clean, replace and maintain.


3. Horizontal mixing and optional vertical mixing design, with high anti-bridge performance.


4. Different models adopt universal screw interface, which can easily replace different types of screws to achieve a wider feeding range of one equipment.


5. Accuracy can reach ±0.5%.


Parameters Table:

model

Feeding amount(KG/H)

motor

Weighing platform

Material contact

Partial material


Seal material

hopper(L)

LW-RT16

0.5-5

servo motor0.4KW

3PhIP55

SCR 15KG, IP65

304 stainless steel

Silicone Rubber

Ding Qing rubber

PTFE

10/20

LW-RT28

5-150

0.75KW, AC 380V3PhIP55

SCR 200KG, 250KG,IP65

304 stainless steel

Silicone Rubber

Ding Qing rubber

PTFE

40/80

LW-RT38

50-600

1.5KW, AC 380V3PhIP55

SCR 200KG, 250KG,IP65

304 stainless steel

Silicone Rubber

Ding Qing rubber

PTFE

80/120/150

LW-RT46

400-1500

1.5KW, AC 380V3PhIP55

SCR 250KG, 300KG,IP65

304 stainless steel

Silicone Rubber

Ding Qing rubber

PTFE

120/150/180

Remarks:

The output is measured by a fluid material, and the feed amount will vary according to the actual material specific gravity and other characteristics.

The actual feeding amount needs to be measured according to the corresponding materials. The specific technical parameters are consulted by the company personnel. If there is any change, no further notice will be given.